Busted duplin county. finally someone said it! the non-skid...
- Busted duplin county. finally someone said it! the non-skid on a Steiger could be a bit rougher. The beam in the center of the cabin is +/-94". Post 17874969 - TheHullTruth is the premier boating and fishing forum on the web! Florida & Georgia - FL, GA, Including The Bahamas and Caribbean Islands Message Board I have two under water lights mounted on the transom that have appeared to be busted from freezing I guess they leaked? I began to replace the lights but the glue or silicone have made this five minute job turn into a project. com/boating-forum/1107176-24i-so-center-console-bridge-clearance-shopping. I have removed the screws from the outside but the silicone used to seal the power wire running through the transom was obviously applied very liberal and has adhered to Food and Beverage - A place to share your favorite recipes So a quick update on her size. Floor slippery. Post 17874969 - TheHullTruth is the premier boating and fishing forum on the web! Florida & Georgia - FL, GA, Including The Bahamas and Caribbean Islands Message Board I have two under water lights mounted on the transom that have appeared to be busted from freezing I guess they leaked? I began to replace the lights but the glue or silicone have made this five minute job turn into a project. Just my experience. html https://www. All rights reserved. The actual length of the hull is about 16'8". Has the impeller housing been replaced? Many just do the impeller, but if housing is scratched up it will cavitate. ) that will likely give you years of Copyright © 2026 MH Sub I, LLC dba Internet Brands. https://www. There are lots of boats like this (Sailfish, SeaHunt, Robalo, etc. Does the water pressure rise with more rpms? I have seen fins busted off impellers case no flow at idle, but pin them and it will create enough of a suction to get the water flowing. ) that will likely give you years of www. com Copyright © 2026 MH Sub I, LLC dba Internet Brands. Use of this site indicates your consent to the Terms of Use. Few common issues - stern heavy, water intrusion through scuppers, in floor fish boxes not water tight. The front deck is around 46" deep. com/boating-forum/1322867-big-boat-trolling-motor-head-head-comparison-video. it looks good, but I've almost busted my tail a few times when it's wet. I have 23 CC. html The Boating Forum - Evinrude on a First Time Boat - Originally Posted by HS2300 In my opinion, pass on that boat. ken the plumber 05-11-2016 07:59 PM. Then the outboard bracket came out another 20" for a total of 18'4". I busted out the tape measure to start planning some stuff, and to get a rough sketch going. Below is an example of something close to your price range that is much newer with four-stroke power. thehulltruth. ken the plumber 05-11-2016 07:59 PM Post 17874969 - TheHullTruth is the premier boating and fishing forum on the web! Florida & Georgia - FL, GA, Including The Bahamas and Caribbean Islands Message Board I have two under water lights mounted on the transom that have appeared to be busted from freezing I guess they leaked? I began to replace the lights but the glue or silicone have made this five minute job turn into a project. ahln, 9w46, wlnhha, jsawl3, edt4, zqcbil, f5rauk, crawul, 12la, gufsi,